When you turn on your TP Link the power LED on the extender will blink and then becomes stable shortly. But what if the power LED on your TP Link WiFi extender blinks longer than expected? Don’t sweat over it! By following the TP Link troubleshooting tips mentioned in this article, you will surely be able to fix the “blinking power TP Link extender LED” issue in no time. Let’s start over!
Resolved: Extender Power LED Blinking
Check the Extender’s Power Adapter
Start by checking the power adapter of your TP Link WiFi range extender. Be sure that the power adapter of your TP Link device is properly plugged in to a well-working wall outlet. Also, ensure that the TP Link extender’s power adapter wire doesn’t have any cuts or damages. Apart from that, your WiFi range extender must receive a constant power supply from the wall outlet you have chosen to plug it.
Check the Extender Hardware
Any damage in the parts of your TP Link WiFi extender may also lead you to the blinking power LED issue. Bear in mind – if any of the extender’s hardware is broken or damaged, get it fixed right away. If you need TP Link troubleshooting tip regarding fixing the extender hardware, drop us a line into the comments section.
Check the Cable Connections
In order to prevent blinking power LED issue on your TP Link WiFi extender, confirm whether all the cables/wires are firmly connected or not. There are possibilities that the cable you are using to connect your TP Link WiFi extender, router, and other WiFi-enabled devices is damaged. So, it is advised to check the cable you are using prior to connecting your devices with each other.
Once you’re done, try accessing the TP Link extender login page to check whether the Ethernet connection between your devices has been successfully established or not.
Power Cycle Your TP Link Extender
Another effective TP link troubleshooting tip to fix the extender power LED blinking issue is to power cycle or restart it once. Follow the steps outlined below in order to restart or power cycle your TP Link WiFi extender:
- Disconnect the connected devices from your TP Link extender’s WiFi including router.
- Unplug your TP Link WiFi extender.
- Wait for 5-7 minutes.
- Plug in back your TP Link WiFi extender again.
- Connect your devices to the extender and try to access TP Link extender setup page.
Check the Internet Connection
You may get a blinking power LED on your TP Link WiFi device if the router you are using is outdated and not compatible with the extender. For this, we suggest you contact your ISP and ask him to update the device immediately (if needed). Apart from this, also make sure to clear all your internet bills (if pending) and get a router that works well with the TP Link extender (if not compatible).
Now, see whether the blinking power LED issue on your TP Link WiFi extender is fixed or not. If yes, then check your internet connection by accessing the tplinkrepeater web page. If the tplinkrepeater web page loads up without displaying any error message, then your internet connection is working fine. If you see tplinkrepeater not working error, then the one and only way to fix this issue is to update your TP Link device’s firmware.
Update the TP Link Extender Firmware
On the off chance if the firmware of your TP Link WiFi extender is outdated, then also you may come across various technical glitches apart from the blinking LED issue. Thus, to fix issues with your TP Link WiFi extender, download and install the latest firmware version on your TP Link WiFi extender right away after performing the TP Link extender setup process. For firmware update instructions, navigate to the device’s official site.
Are the TP Link troubleshooting tips provided in this article proving helpful to you? Your feedback matters a lot to us!
